AbsoluteBlack Graphene wax

GRAPHENwax ® has a very low friction coefficient, is long-lasting and easy to use.

• The wax is black in color, but transparent when melted.
• Does not leave marks or smears.
• The quietest wax to work with.
• Contains a special high-purity graphene blend.
• Does not contain harmful solvents.
• Does not containtungsten disulfide (WS2) or molybdenum disulfide (MoS2)
• Quantity: 87g solid block

After dipping the chain in wax, wait until the chain has cooled down and run it through your fingers, after which the chain is ready for use. AbsoluteBlack wax does not crumble when the chain is in motion, so it lasts longer on the chain compared to other waxes. GRAPHENwax ® also withstands hot weather well and does not melt off.

Why is AbsoluteBlack Graphene wax better than other hot melt waxes?

• After waxing, you don’t have to bend the chain links one by one to achieve normal chain flexibility.
• The quietest hot melt wax.
• Does not crack like other waxes.
• You don’t have to take the chain apart like with other waxes.
• Quiet because it stays on the chain plates better
• Melts quickly when heated
• Lasts longer thanks to the flexibility of the wax and the addition of graphene
• Very low friction coefficient
• Does not melt off the chain on hot days

How long does the wax last?

Each use requires approx. 3-4g of wax if you let the wax drip back into the pot.

How to use GRAPHENwax ®:

Remove the chain from the bike or use a new chain and clean it with solvent by placing the chain completely in the solvent for 20-60 minutes, using the bag that came with the wax (transparent film). Finally, shake the bag with the chain for 2 minutes. Remove the chain and allow it to dry completely (10-12 hours – very important). If desired, you can rinse the chain with 98% alcohol to remove any remaining residue. Once the chain is completely dry (10-12 hours), then:

1. Melt the wax completely in a pot. The melting temperature of wax is 70°C. But heat it to 90-100°C!
2. Place the chain in the wax so that it is completely covered. Wait until the wax that has accumulated on the chain melts again (10-15 minutes – IMPORTANT!). The best way to do this is to use a metal clothespin (wear gloves).
3. Gently move the chain (up and down, left and right) for about 3-5 minutes so that the wax gets everywhere.
4. Remove the chain and hang it up. Gently wipe off any excess wax from the side plates and let the chain cool for about 15 minutes. Once it has reached room temperature (40 min), hold the chain in one hand and push it through between two fingers of your free hand.
5. Done!

Re-waxing intervals:

The wax lasts for about 450 km in dry conditions. If the chain sounds dry, it’s time to re-wax it. If you ride in rainy/wet conditions, ideally you should reapply wax after every ride.